Ricoh B089 Service Manual page 258

SERVICE PROGRAM MODE
5816 11 Port 80 Enable
5821 Remote Service Address
5821 1 CSS PI Device Code DFU. Japan Only
Sets the PI device code. After changing this setting, you must switch the machine
off and on.
5821 2 RCG IP Address DFU. Japan Only
Sets the IP address of the RCG (Remote Communication Gate) destination for call
processing at the remote service center.
[00000000h ~ FFFFFFFFh/ 00000000h /
5824 NVRAM Data Upload
Uploads the UP and SP mode data (except for counters and the serial number)
from the NVRAM on the control board to a flash memory card. (! 4.2.8)
While using this SP mode, always keep the front cover open. This prevents a
software module accessing the NVRAM during the upload.
5825 NVRAM Data Download
Downloads the content of a flash memory card to the NVRAM on the control
board. (! 4.2.8 )
While using this SP mode, always keep the front cover open. This prevents a
software module accessing the NVRAM during the download.
After executing this SP, switch the copier off and on.
B089/B093
Determines whether permission is granted for
access to the SOAP method via Port 80 on the
NRS network.
0: No. Access denied
1: Yes. Access granted.
4-42 SM