Sp1Xxx: Feed - Ricoh B089 Service Manual

SP1XXX: Feed

1001* Leading Edge Registration
1001 1 Paper Tray Feed
1001 2 By-pass Feed
1001 3 Duplex, Side2
1002* Side-to-Side Registration
1002 1 Tray 1
1002 2 Tray 2
1002 3 Tray 3 (Optional PFU Tray 1, or
LCT)
1002 4 Tray 4 (Optional PFU Tray 2)
1002 5 By-pass
1002 6 Duplex Side 2
1003* Paper Feed Timing
1003 1 Tray 1
1003 2 Tray 2/3/4 By-pass
1003 3 Duplex Side 2
1007 By-pass Paper Size Display
1103 Fusing Idling
Switches fusing idling on/off.
Switch on if fusing on the 1st and 2nd copies is incomplete (this may occur if the
room is cold.)
SM
SERVICE PROGRAM MODE
[+9.0 ~ –9.0 / +0.0 / 0.1 mm/step]
Adjusts the printing leading edge registration from
each paper feed station using the Trimming Area
Pattern (SP4417, No.15).
Use the  key to toggle between + and – before
entering the value.
The specification is 3 ± 2 mm.
See "Replacement and Adjustment - Copy
Adjustment" for details.
[+9.0 ~ –9.0 / +0.0 / 0.1 mm/step]
Adjusts the printing side-to-side registration
from each paper feed station using the
Trimming Area Pattern (SP4417, No.15).
Use the  key to toggle between + and –
before entering the value. The specification is
±
2 1.5 mm. See "Replacement and
Adjustment - Copy Adjustment" for details.
Adjusts the paper feed clutch timing at registration.
The paper feed clutch timing determines the amount
of paper buckle at registration. (A larger setting leads
to more buckling.)
[0 ~ 10 / 5 / 1 mm/step]
[0 ~ 20 / 6 / 1 mm/step]
Displays the by-pass paper width sensor output.
[0 = Off / 1 = On / 2 = Off plus machine
4-7
temperature check]
B089/B093