Ricoh B089 Service Manual page 271

Rev. 06/2004
5912* PCU Alarm Setting
5912 1 Display
5912 2 Interval
5913 Switchover Permission Time
Sets the amount of time to elapse while the machine is in standby mode (and the
operation panel keys have not been used) before another application can gain
control of the display.
[3~30 / 3 / 1 s]
5914* Application Counter Display
5914 1 Printer Counter (0:OFF 1:ON
5914 2 Fax Counter (0:OFF 1:ON)
5914 3 Copy Count (0:OFF 1:ON)
5915* Mechanical Counter Detection
Checks whether the mechanical counter inside the inner cover is connected or
not.
Display:
0: Not detected
1: Detected
2: Unknown
5918* A3/DLT Counter Display
Displays the counter, which counts A3/DLT as double.
0 = No, 1 = Yes
The A3/DLT counter counts up twice when an A3 or DLT sheet is fed out.
Low Power Mode Recovery time DFU
5920
5921*
Exhaust Fan Control
Sets the timing for slowing the exhaust fan motor speed or shutting the motor off
for normal operation, depending on the following conditions:
1. After the machine has entered energy saver mode or stand-by mode, the
machine slows the fan speed after this time runs out.
2. After the machine has entered the auto off mode or an error occurs, the
machine stops the fan after this time runs out.
[30 ~ 120 / 30 s / 1 s]
SM
Selects whether the PCU alarm message (Change Photoconductor
Unit) blinks when the PCU alarm interval expires.
When installing the machine, if the customer requires that the PCU
alarm message blink, select "1". If set to "0", there will be no message.
[0 = No / 1 = Yes]
Sets the PCU alarm interval.
When the machine reaches this value, the PCU alarm will be
displayed on the LCD to inform the user. Only used if SP59121 is at
"1".
[1 ~ 255 / 60 / 1 k copies/step]
4-55
SERVICE PROGRAM MODE
[0 = No / 1 = Yes]
Selects whether the total counters for
printer mode and/or copy mode are
displayed in user tool mode.
B089/B093