Ricoh B089 Service Manual page 708

DEDICATED TRANSMISSION PARAMETERS
Switch 03
No FUNCTION
0 Inch-mm conversion before tx
Bit 1 Bit 0
to
0 0
1
0 1
1 0
1 1
2 DIS/NSF detection method
to Bit 3 Bit 2
3 0 0
0 1
1 0
1 1
4 V.8 protocol
0: Off
1: Disabled
5
Compression modes available
in transmit mode
0: MH only
1: Disabled
6 ECM during transmission
to Bit 7 Bit 6
7 0 0
0 1
1 0
1 1
Switch 04 - Not used (do not change the settings)
Switch 05 - Not used (do not change the settings)
Switch 06 - Not used (do not change the settings)
Switch 07 - Not used (do not change the settings)
Switch 08 - Not used (do not change the settings)
Switch 09 - Not used (do not change the settings)
B576
The machine uses inch-based resolutions for
Setting scanning. If "inch only" is selected, the printed copy
Inch-mm may be slightly distorted at the other end if that
conversion machine uses mm-based resolutions.
available
Inch only
If the setting is "Disabled", the bit switch setting is
Not used
used.
Disabled
(0, 1): Use this setting if echoes on the line are
Setting interfering with the set-up protocol at the start of
First DIS or transmission. The machine will then wait for the
NSF second DIS or NSF before sending DCS or NSS.
Second DIS or
NSF
If the setting is "Disabled", the bit switch setting is
Not used
used.
Disabled
If transmissions to a specific destination always end
at a lower modem rate (14,400 bps or lower),
disable V.8 protocol so as not to use V.34 protocol.
0: V.34 communication will not be possible.
If the setting is "Disabled", the bit switch setting is
used.
This bit determines the capabilities that are informed
to the other terminal during transmission.
If the setting is "Disabled", the bit switch setting is
used.
For example, if ECM is switched on but is not
Setting wanted when sending to a particular terminal, use
Off the (0, 0) setting.
On
Note that V.8/V.34 protocol and JBIG compression
Not used
are automatically disabled if ECM is disabled.
Disabled
If the setting is "Disabled", the bit switch setting is
used.
COMMENTS
3-68 SM