Ricoh B089 Service Manual page 204

OPTIONAL BOARDS AND DIMMS
5. Pull off the edge connector protector [A] off the card and discard it.
⇒
6. With the card label facing the front, insert the card [B] into the PCI slot.
7. Use the Velcro pads to install the antennas [C] on the left rear corner of the
machine.
NOTE: The antennas should be separated by at least 40 ~ 60 mm (1.5~2.5").
Always detach the antennas from the corners of the machine and
disconnect them before moving the machine.
8. Connect the antennas to the terminals [D].
9. Coil the cables [E] and hang them over the antennas as shown.
10. Attach the cover [F] (
11. If reception is poor, you may need to move the machine:
• Make sure that the machine is not located near an appliance or any type of
equipment that can generate a strong magnetic field.
• Position the machine as close as possible to the access point.
B089/B093
[C]
[B]
x 2).
3-70
[D]
B515R107.WMF
[A]
Rev. 06/2004
[E]
[F]
SM