Ricoh B089 Service Manual page 659

Rev. 04/2004
System Switch 1E
No FUNCTION
2 RTI/CSI display priority
0: RTI 1: CSI
3 File No. printing
0: Enabled
1: Disabled
⇒
4
This switch allows or prohibits all
fax reception when Authorized
Reception is enabled and no
RTI/CSIs have been
programmed.
0: All fax receptions are
enabled
1: All fax receptions are disabled
5-6 Not used
7 RAM initialization after the
optional Function Upgrade unit
is installed or removed
0: Enabled
1: Disabled
SM
COMMENTS
This bit determines which identifier, RTI or CSI, is
displayed on the LCD while the machine is
communicating in G3 non-standard mode.
1: File numbers are not printed on any reports.
This switch is only effective when Authorized Reception
is enabled and there are no RTI/CSIs programmed.
Under these two conditions:
The default setting of "0" allows the machine to receive
all incoming faxes. This is useful in cases where the
customer has mistakenly enabled Authorized Reception
with no RTI/CSIs programmed.
Setting this switch to "1" will cause the machine to
reject all incoming transmissions.
Do not change the setting.
When the machine detects that a Function Upgrade
unit has been installed or removed, the machine
shows the following message on the display for the
customer.
"Adding/Removing FAX Feature Expander causes
data loss. Turn Main Power Switch off and
remove/replace it to avoid loss. To continue, press
Yes."
If Yes is pressed, the machine initializes the RAM to
the "with" or "without card" configuration. However,
changing this bit to "1" disables this initialization,
even if Yes is pressed.
Change this bit to 1 after installing the Function
Upgrade unit.
0: When the above message is displayed, the
machine initializes the RAM if Yes is pressed. The
amount of data lost depends on whether the board is
in or out. To avoid losing data, the user must switch
off immediately and put the Function Upgrade unit
back in.
1: When the above message is displayed, the
machine does not initialize the RAM even if Yes is
pressed. However, the fax unit cannot be used until
the user switches off, puts the Function Upgrade unit
back in, then switches back on. No data is lost.
3-19
BIT SWITCHES
SP No. 1-101-031
B576