Ardf Output Check (Sp); Finisher Output Check (Sp) - Ricoh B089 Service Manual

SERVICE PROGRAM MODE
ARDF Output Check (SP6008)
1. Open SP mode SP6008.
2. Select the SP number that corresponds to the component you wish to check.
(Refer to the table below.)
3. Press On then press Off to test the selected item. You cannot exit and close
this display until you click Off to switch off the output check currently executing.
No. Description
1 Feed Motor (Fwd)
2 Feed-in Motor (Rev)
3 Transport Motor (Fwd)
4 Feed Clutch
5 Pick-up Solenoid
6 Junction Gate Solenoid
7 Stamp Solenoid
Finisher Output Check (SP6118)
1. Open SP mode SP6118.
2. Select the SP number that corresponds to the component you wish to check.
(Refer to the table below.)
3. Press On then press Off to test the selected item. You cannot exit and close
this display until you click Off to switch off the output check currently executing.
No.
1 Upper Transport Motor
2 Shift Tray Lift Motor
3 Staple Hammer Motor
4 Shift Motor
5 Lower Transport Motor
6 Shift Tray Exit Motor
7 Tray Junction Gate Solenoid
8 Jogger Motor
9 Stapler Motor
10 Stapler Junction Gate Solenoid
11 Positioning Roller Solenoid
12 Stack Feed-out Motor
13 Exit Guide Plate Motor
14 Not Used
15 Not Used
16 Not Used
17
B089/B093
1000-sheet finisher
Description
500-sheet finisher
Main Motor
Output Tray Motor
Stapler Motor
Jogger Motor
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Paddle Roller Solenoid
Exit Unit Gear Solenoid
Stack Height Lever Solenoid
4-108 SM