Registering The Card Ids - Canon imageRUNNER 2530 Service Manual

Registering the Card IDs

After installing the Card Reader, register the card numbers to be used in the service mode of the host machine.
If they are not registered, cards will not be recognized when inserted.
1) Plug the power cord into the outlet.
2) Turn on the main power switch.
3) When a message appears on the control panel display, press the following keys to enter the service mode:
> 2 Key > 8 Key >
4) Get in Service Mode (# ACC> CARD) and enter the card number to use (1 to 2000).
- Enter the smallest card number of the cards used by the user.
- From the entered number, up to 1000 cards can be used.
5) Turn main power switch off and on again.
6) Insert the card with registered valid number to check it's at standby state.
9
Installation > Card Reader Installation Procedure > Registering the Card IDs
9 Installation > Card Reader Installation Procedure > Registering the Card IDs
9-29
9-29