Canon imageRUNNER 2530 Service Manual page 308

17) Connect the connector at the heater side to the Heater Relay Harness.
19) Install the Heater PCB.
20) Connect 4 connectors to the Heater PCB.
21) I
nstall the removed covers.
•
Lower rear cover
•
Connector cover
•
Delivery tray
•
Inside base cover
•
Screw on Left cover
•
Right cover(upper)
22) Close the Right cover.
23) Close the Toner supply cover.
24) Close the Front cover.
25) Install the removed Cassettes.
26) Check that the Environment Heater switch is ON
27) Plug the power plug of the host machine to the outlet.
28) Turn ON the main power switch.
9
Installation > Cassette Heater Unit 37 > Installation Procedure > In case of Host Machine(250 Sheets of Cassette Model)
18) Affix the Warning High Temperature Label to the specified area. (area between screw holes on the Base Plate)
CAUTION:
Label Warning high
temp label use a label
corresponding to the
language.
F-9-163
9 Installation > Cassette Heater Unit 37 > Installation Procedure > In case of Host Machine(250 Sheets of Cassette Model)
Warning high temp label
9-72
F-9-164
9-72