Canon imageRUNNER 2530 Service Manual page 262

18) Connect the connector of the repeating harness B to the repeating harness C.
Connect the connector without the protective tube of repeating harness C.
x1
20) Secure the repeating harness C to the 8 clamps from the reader side, and route the repeating harness C shown in the Figure.
CAUTION:
Put the core between
clamps shown in the Figure.
9
Installation > Card Reader Installation Procedure > Installation Procedure
19) Connect the connector of the repeating harness C to the connector J8119 on the main controller PCB.
F-9-58 F-9-58
x8
9 Installation > Card Reader Installation Procedure > Installation Procedure
9-26
x1
F-9-59 F-9-59
Clamp
Core
F-9-60 F-9-60
9-26