Canon imageRUNNER 2530 Service Manual page 101

2
Technology > Embedded RDS > E-RDS Setup > Network settings
c. Press [OK].
d. Press [Done].
DNS Settings
e. Move on to Settings/ Registration > System Settings > Network Settings > TCP/IP Settings
> IPv4 Settings > DNS Server.
f. Set the DNS settings, based on the information obtained under (2) Advance preparations,
Information item 2, described above.
•
Select DNS Server Address Settings, if IP addresses are specified directly.
2 Technology > Embedded RDS > E-RDS Setup > Network settings
•
F-2-102 F-2-102
•
g. Press [Done].
F-2-103 F-2-103
1) Select Primary DNS Server, and then set the DNS server address.
Example) 172. 001.016. 010
2) If secondary DNS server is set, select and set Secondary DNS Server address.
3) 4) press [OK].
If DNS host name is used, select DNS Host Name/Domain Name Settings, and then
specify the host name.
If a DHCP server is established and DNS Dynamic Update Settings is not applied, reserve
the fix IP address to said device.
2-73
F-2-104 F-2-104
2-73