Canon imageRUNNER 2530 Service Manual page 283

8) Remove the left cover.
•
Screw (1 pc.)
x1
Link Rod
CAUTION:
There is the link rod behind the left cover, which is engaged to the switch
on the power supply unit. So carefully remove the left cover not to give an
excessive lord on the link rod.
9) Install the heater SW harness firmly in the power cord bracket.
9
Installation > Cst Heater Kit-J1 Installation Procedure > Installation Procedure
MEMO:
When reinstalling the left cover, surely insert the link rod in the switch on the power supply unit so the
switch does link to the main power switch of the host machine.
x1
F-9-99 F-9-99
F-9-101 F-9-101
9 Installation > Cst Heater Kit-J1 Installation Procedure > Installation Procedure
x2
MEMO:
Install the heater SW harness in the correct direction
referring to the curved seals in the power cord bracket.
Relative positions of "I" and "O" symbol of the switch must
be the same as the curved seals.
9-47
F-9-100 F-9-100
9-47