Canon imageRUNNER 2530 Service Manual page 285

13) Unlock the wire saddles and stretch the folded harness as shown. Then joint the connector to the heater PCB.
x2
14) Joint the connector of the heater DC harness, which is closer to the protective tube of the harness to J1102 of the heater PCB.
15) Clamp the 3 harnesses as shown in the figure.
CAUTION:
Scatter the slack of the wire and comfirm which the do not touch the part of the primary circuit.
9
Installation > Cst Heater Kit-J1 Installation Procedure > Installation Procedure
x1
9 Installation > Cst Heater Kit-J1 Installation Procedure > Installation Procedure
x1
F-9-106 F-9-106
9-49
F-9-105 F-9-105
9-49