Canon imageRUNNER 2530 Service Manual page 272

5) To remove the core, cut the cable holder at the position shown below using nippers.
6) Cut the cable ties, and then remove the core of the control card cable.
7) Connect the connector of the control card cable to the connector on the image processor PCB as
shown.
x1
9
Installation > Control Interface Cable-A1 Installation Procedure > Installation Procedure
F-9-79 F-9-79
8) Route the harness as shown.
•
Clamp (1 pc.)
F-9-80 F-9-80
9 Installation > Control Interface Cable-A1 Installation Procedure > Installation Procedure
x1
9-36
F-9-81 F-9-81
9-36