Shelf Mounting The Scopia Elite 5200 Series Mcu; Connecting Cables To The Scopia Elite Mcu - RADVision SCOPIA Elite 5200 Series Installation Manual

Shelf Mounting the SCOPIA Elite 5200 Series MCU

During the shelf mounting procedure you must secure the MCU in its position on a shelf to prevent
it from moving around on the shelf or falling.
Procedure
Step 1
Verify that the shelf you want to use is properly mounted and secured.
Step 2
Verify that the shelf can support the MCU weight.
Step 3
Fix the integral mounting brackets of the MCU to the shelf rails.

Connecting Cables to the SCOPIA Elite MCU

Follow the safety guidelines described in the Safety Guide for the SCOPIA Elite MCU during this
procedure, and use the network and the serial cables supplied with the accessories kit.
Procedure
Step 1
Connect the power cable:
a.
b.
Figure 3-6
c.
d.
RADVISION | Installation Guide for SCOPIA Elite 5200 Series MCU Version 7.5
Turn off the power distribution unit (PDU).
On the rear side of the MCU, plug in the power cable into the AC power connector.
The AC Power Connector and Power Switch of the SCOPIA Elite MCU
On the rear side of the MCU, power on the MCU using the On/Off switch.
Turn on the power distribution unit (PDU).
Setting up the SCOPIA Elite 5200 Series MCU | 14