Connecting To The Processor With Tcp/Ip; Downloading The Project To The Processor - ProSoft Technology ProTalk PTQ-104C User Manual

49TPTQ-104C ♦ 48TQuantum Platform
47TIEC 60870-5-104 Client

2.4.1 Connecting to the Processor with TCP/IP

The next step is to download (copy) the project file to the processor. The
following steps demonstrate how to use an Ethernet cable connected from the
Processor to the PC through an Ethernet hub or switch. Other connection
methods may also be available, depending on the hardware configuration of the
processor and the communication drivers installed in Unity Pro.
1 Connect the PC and the processor to an Ethernet hub.
2 Open the PLC menu, and select S
Important: The Set Address dialog box is divided into two areas. Enter the address and media
type in the PLC area of the dialog box, not the S
3 Enter the IP address in the address field. In the M
'TCPIP'.
4 Click the T
2.5

Downloading the Project to the Processor

1 Open the PLC menu and then choose C
connection between the Unity Pro software and the processor, using the
address and media type settings that were configured in the previous step.
2 On the PLC menu, choose T
the T
RANSFER
mode immediately after the transfer is complete, select (check) the PLC R
T
AFTER RANSFER
ProSoft Technology, Inc.
March 4, 2013
C button to verify that the settings.
EST ONNECTION
RANSFER
P PLC dialog box. If the PLC needs to go to "Run"
ROJECT TO
check box.
Configuring the Processor with Unity Pro
.
ET ADDRESS
area.
IMULATOR
dropdown list, choose
EDIA
. This action opens a
ONNECT
P PLC. This action opens
ROJECT TO
12TUser Manual
UN
Page 29 of 136