Sony PDW-HD1500 Operation Manual page 99

Item number Item name
717 CHROMA PHASE CONTROL
718 SETUP LEVEL (59.94i mode)/
BLACK LEVEL (50i mode)
719 SYSTEM PHASE SYNC
720 SYSTEM PHASE SC
723 INPUT VIDEO BLANKING
Sub-item
1 ALL LINE
2 ... 10 LINE 12 ...
LINE 20
2 ... 15 LINE 9 ...
LINE 22
726 H BLANKING WIDTH
728 OUTPUT SCH PHASE
731
WIDE MODE
Sub-item
1 INPUT
2 OUTPUT
Menu items in the 700s, relating to video control
Settings
Adjust the chroma phase.
–128 to 0 to 127
Adjust the setup level (black level).
–272 to 0 to 272
Adjust the output signal sync phase.
–128 to 0 to 127
Adjust the output signal subcarrier phase.
0 to 511
Switch blanking on or off for individual lines in the vertical blanking
interval of an input video signal. The Y/C signal and odd/even fields are
blanked simultaneously.
A signal with blanking carried out according to this setting is recorded.
- - -: Specify the blanking for each line separately.
blnk (blank): Regardless of the setting of other sub-items, blank all lines
which can be specified in this menu item.
thru (throu): Regardless of the setting of other sub-items, switch off
blanking for all lines which can be specified in this menu item.
In 59.94i Specify blanking for lines 12 to 20.
mode blnk (blank): Carry out blanking.
thru (throu): Switch off blanking.
In 50i Specify blanking for lines 9 to 22.
mode blnk (blank): Carry out blanking.
thru (throu): Switch off blanking.
Select the horizontal blanking width of the output analog video signal.
narow (narrow): Digital blanking (narrow)
wide: Analog blanking (wide)
When "wide" is selected, the horizontal blanking width complies with
RS170A, and normally the blanking is widened and the image becomes
narrower. It is recommended to select "narow" at the editing stage, then
later, for broadcast transmission to select "wide", to output a signal
conforming to the standard. Note, however, that "narow" has to be always
selected for SDI signals.
Set the subcarrier H phase.
–512 (–512 (DEC))... 0 (0 (DEC))... 511 (511 (DEC))
Specify whether to record and play back with the addition of wide picture
information.
Specify whether to save wide picture information on a disc during
recording.
auto: Automatically record wide picture information when it is detected in
the selected input video signal.
on: Always record wide picture information.
off: Do not record wide picture information.
Specify whether to add wide picture information to the output signal
during MPEG IMX playback.
thru (through): Output the video signals of the disc being played back
without adding wide picture information.
auto: When wide picture information is detected on the disc being played
back, add wide picture information to the output video signals.
Notes
• To add wide picture information to the output signal, it is necessary, in
addition to setting this item to "thru", to operate setup menu item 703 to
set line 20 (in 59.94i mode) to "thru" or set line 23 (in 50i mode) to
"thru".
• In 59.94i mode, wide picture information may not be output if VITC
signal insertion position is set to line 20 in setup menu item 601 or 602.
99
Setup Menu