Sony PDW-HD1500 Operation Manual page 24

CAUTION
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
ATTENTION
Par mesure de sécurité, ne raccordez pas le connecteur
pour le câblage de périphériques pouvant avoir une tension
excessive à ce port. Suivez les instructions pour ce port.
ACHTUNG
Aus Sicherheitsgründen nicht mit einem Peripheriegerät-
Anschluss verbinden, der zu starke Spannung für diese
Buchse haben könnte. Folgen Sie den Anweisungen für
diese Buchse.
i MAINTENANCE connectors (High Speed USB
(USB 2.0) Type-A)
These are the USB connectors for maintenance.
j SDSDI OUTPUT1, 2 (SUPER) (SDI signal outputs
1, 2 (superimpose)) connectors (BNC type)
These output SDSDI format video/audio signals.
When the unit is shipped from the factory, audio signal
output is 8 channels with no switching, and RP188
timecode output is set to on. You can change these settings
with setup menu item 828 SDI AUDIO OUTPUT
SELECT and setup menu item 920 SD-SDI H-ANC
CONTROL.
The output from the 2 (SUPER) connector can have
timecode, menu settings, alarm messages, and other text
information superimposed. To turn superimposition off,
set CHAR SEL on the HOME page of the function menu
to "OFF".
See "Items in the extended menu" (page 92) for more
information.
See "Basic Operations of the Function Menu" (page 40)
for more information.
A Power supply section
1 Power switch
POWER
24
Rear Panel
2 - AC IN connector
AC IN
a Power (main power) switch
Press the : side to power on the unit. Press the a side to
power off.
When using the unit, normally leave the POWER switch in
the : (on) position, and use the on/standby button on the
front panel to switch the unit between the operating state
and standby state.
Note
Before turning the main power off, always check to be sure
that the unit is in the standby state, and then push the main
power switch to the a side.
b -AC IN connector
Connect to an AC power supply with the power cord (not
supplied).
B Analog audio signal input/output section
1 ANALOG AUDIO INPUT 1, 2 connectors
ANALOG AUDIO INPUT
ANALOG AUDIO OUTPUT
1 2
3 AUDIO MONITOR R, L connectors
a ANALOG AUDIO INPUT 1, 2 connectors (XLR 3-
pin, female)
These input analog audio signals.
With A1 INPUT or A2 INPUT on page P2 AUDIO, and
A3 INPUT or A4 INPUT on page P3 AUDIO of the
function menu (see page 42), you can select whether the
signal input to connector 1 is assigned to audio channel 1or
3, and whether the signal input to connector 2 is assigned
to audio channel 2 or 4.
You can set the reference input level with the maintenance
menu item M37: AUDIO CONFIG (see page 104).
(Factory default setting: +4 dB)
Microphone settings
If you have connected a microphone to this unit, you can
set input level, AGC, and delimiter values for the
microphone with setup menu items 834, 839, 840, and 841
(see page 101).
Note
An unpleasant sound may be output if you have connected
a microphone to the ANALOG AUDIO INPUT 1 or 2
connector and power the microphone on with the input
level too high. Check the input level setting before
connecting a microphone.
2 ANALOG AUDIO OUTPUT 1, 2
connectors
AUDIO MONITOR
1 2 R L