Sony PDW-HD1500 Operation Manual page 94

Item number Item name
131 AUDIO VOLUME
140 AREA MARKER
142
REPEAT MODE
143 INDEX PICTURE POSITION
Item number Item name
201 PARA RUN
214 REMOTE INTERFACE
257 NETWORK ENABLE
Item number Item name
301 VAR SPEED RANGE FOR
SYNCHRONIZATION
94
Setup Menu
Menu items in the 100s, relating to the control panels
Settings
Select whether each of the CH-1/ALL CH, CH-2 to CH-4 adjustment
knobs on the control panel is effective to control the audio recording level
and playback level on each channel or the CH-1/ALL CH adjustment
knob alone functions as a master control to control the audio level on all
channels together.
each: Each of the CH-1/ALL CH, CH-2 to CH-4 adjustment knobs is
effective to control each channel.
all: The CH-1/ALL CH adjustment knob alone functions as a master
control.
When "all" is selected, the ALL CH indicator under the CH-1/ALL CH
adjustment knob lights up.
Select whether the down-converted SD output signal is displayed on the
display or whether the down-convert mode is displayed on the display.
off: Do not display.
on: Display.
Put the unit into repeat playback mode, or exit from repeat playback
mode.
off: Exits from repeat playback mode.
play: Puts the unit into repeat playback mode.
Select the frame of the clip to use as the thumbnail image (index picture)
when recording.
0sec to 10sec: Can be set in the range from 0 seconds (first frame of the
clip) to10 seconds, in units of 1 second.
Menu items in the 200s, relating to the remote control interface
Settings
Select whether to use synchronized operation for two or more VTRs.
dis (disable): No synchronized operationena
ena (enable): Use synchronized operation
Note
To use synchronized operation for two or more VTRs, set item 201 to ena
on all of the VTRs.
When the remote control switch is set to REMOTE, select the device from
which to remote-control this unit.
9PIN: Device connected to the REMOTE connector.
i.LNK (i.LINK): Device connected to the S400 (i.LINK) connector.
SDI: Device connected to the HDSDI INPUT connector.
Select the remote control switch positions which enable network
connections.
net (network): Only when the switch is set to "NET".
n&9P (network & remote(9PIN)): When the switch is set to "NET", and
when the switch is set to "REMOTE" and setup menu item 214 is set
to "9PIN".
a) FTP connections can be made only when the device connected to the REMOTE
connector (D-sub 9 pin) is in stop mode. During FTP connections, the device connected
to the REMOTE connector cannot be used to control this unit.
Menu items in the 300s, relating to editing operations
Settings
Select the playback speed range when carrying out playback in variable
speed mode from a remote control unit connected to the REMOTE
connector.
–2~+2: –2 to +2 times normal speed.
wide: –2.20 to +2.20 times normal speed.
a)