Sony PDW-HD1500 Operation Manual page 100

Item number Item name
740 MASTER LEVEL (HD)
741 Y LEVEL (HD)
742 PB LEVEL (HD)
743 PR LEVEL (HD)
745 SETUP LEVEL (HD)
746 SYNC PHASE (HD)
747 FINE (HD)
Item number Item name
802 DIGITAL AUDIO MUTING IN
SHUTTLE MODE
807 AUDIO OUTPUT PHASE
808 INTERNAL AUDIO SIGNAL
GENERATOR
815 AUDIO SAMPLING RATE
CONVERTER
823 NON-AUDIO FLAG PB
Sub-item
1 CH1/CH2
2 CH3/CH4
3 CH5/CH6
4 CH7/CH8
100
Setup Menu
Menu items in the 700s, relating to video control
Settings
Adjust the high-definition video signal output from the HDSDI OUTPUT 1,
2 (SUPER) connectors. This adjusts the Y, PB, and PR levels
simultaneously.
–2048 to 0 to 846
Adjust the Y level of the high-definition video signal output from the
HDSDI OUTPUT 1, 2 (SUPER) connectors.
–2048 to 0 to 846
Adjust the PB level of the high-definition video signal output from the
HDSDI OUTPUT 1, 2 (SUPER) connectors.
–2048 to 0 to 846
Adjust the PR level of the high-definition video signal output from the
HDSDI OUTPUT 1, 2 (SUPER) connectors.
–2048 to 0 to 846
Adjust the setup level of the high-definition video signal output from the
HDSDI OUTPUT 1, 2 (SUPER) connectors.
–272 to 0 to 272
Control the H sync phase of the high-definition video signal output from
the HDSDI OUTPUT 1, 2 (SUPER) connectors.
–128 to 0 to 127
Fine control the H sync phase of the high-definition video signal output
from the HDSDI OUTPUT 1, 2 (SUPER) connectors.
0 to 1023
Menu items in the 800s, relating to audio control
Settings
Set the audio muting conditions during shuttle playback.
off: Not muted.
on: Muted.
Set the output timing of digital audio playback signals (HDSDI, SDI, AES/
EBU only), with 80H as a reference position. Output timing is earlier for
values smaller than 80H and later for values greater than 80H. (80H, 128
samples = approx. 2.7 ms, 80H, 1 sample = approx. 20 μs)
0 (0 (HEX))... 80 (80 (HEX))... FF (FF (HEX)): Values can be set in this
range.
Select the operation of the internal audio test signal generator.
silnc (silence): Silent signal.
1kHz (1kHz sine): 1 kHz, –20 dB FS sine wave signal.
When you select SG as the audio input in the input selection section of
the control panel, the audio test signal generated by the internal audio
test signal generator is input.
Select the mode of operation of the sampling rate converter for AES/
EBU input to channels 1 to 4.
off: Do not operate.
on: Operate.
Control non-audio flags in digital audio output.
During playback (except E-E mode), set non-audio flags in digital audio
output to the following states.
on: Set to on (data is non-audio.)
auto: Set as follows.
• When data is read from disc and confirmed: Follow the data.
• When data from disc is not confirmed: Maintain current state.