Making Additional Routes; Creating A Route Using Marks On The Chart Page - Standard Horizon CP590 Owner's Manual

6. Then move the ShuttlePoint knob to the last Waypoint.
7. Press [O
LYMPIC
9.3

MAKING ADDITIONAL ROUTES

To create another Route the GPS Chart Plotter must be told that you want to create a
second Route.
1. Move the ShuttlePoint knob to the existing Route and then press [E
2. Move the ShuttlePoint knob to highlight SELECT and press [ENT].
3. Move the ShuttlePoint knob to an open Route number: example, Route 2. Press [ENT].
4. Press [CLR].
5. To create the new Route, follow now the steps in the previous section "Creating a Route
using Waypoints".
9.4

CREATING A ROUTE USING MARKS ON THE CHART PAGE

To create a Route containing Marks you first must create the Marks and show them on the
Chart page.
1. Move the ShuttlePoint knob over the top of a Mark that you wish to be the starting point
in the Route and press [ROUTE].
2. Next move the ShuttlePoint knob until the cursor is over the Mark that you want to be
the next leg in the Route.
3. Press [ROUTE]. You will notice a bearing line joins the first and second Mark which
means these Marks are selected into the Route.
4. Repeat steps 3 and 4 until all Marks are entered into the Route.
At this point the Route is saved as ROUTE01. If you would like to save the Route under a specific
name follow the steps on the previous Par. 9.1.
CP590
]. A line joins the starting Waypoint and the last Waypoint.
WAAS 3D
Figure 9.2a - Olympic Route creation (2)
Figure 9.3 - Create additional Route
WAAS 3D
NOTE
WAAS 3D
].
DIT
Page 69