Reading Micr Characters On Personal Checks; Cleaning The Micr Mechanism - Epson TM-U675 User Manual

l
English English
MICR Option (factory option)

Reading MICR Characters On Personal Checks

CAUTION:
Do not insert checks with staples in them. This may cause paper jams,
MICR reading errors, and damage to the MICR head.
Be sure the checks are flat, without curls, folds, or wrinkles.
1. Wait until the SLIP light blinks. Then insert the check face up
with the right side of the check against the right side of the
paper inlet as far as it will go. Be sure that the MICR characters
are on the right.
2. The printer will detect the check and start drawing it in. When
the printer starts drawing it in, let go of the check immediately.
When the printer ejects the check and the SLIP light starts
blinking again; remove the check by pulling it straight up; do
not pull it at an angle.

Cleaning the MICR Mechanism

Once a year clean the MICR head with a moistened cleaning sheet.
Use the following or an equivalent commercially available cleaning
sheet:
PRESAT brand (KIC) "CHECK READER CLEANING CARD."
Note:
Be sure not to use an adhesive cleaning sheet.
10 TM-U675/U675P User's Manual
MICR
characters
on this side
face up