Caution Regarding Ink System Removal, Pf Roller Unit Removal And Pf Motor Removal - Epson Stylus C 60 Service Manual

EPSON Stylus C60
4.2.11 Caution regarding Ink system removal, PF roller
unit removal and PF motor removal
In case that you remove or replace the Ink system (Cap unit & Pump unit),
the PF roller unit and PF motor, we recommend to replace to new Printer
mechanism with the Lower housing
This is because these parts have to be removed or replaced with the Printer
mechanism condition without the Lower housing.
If you perform the operation with the condition, the Main frame is deform
and the product quality may be lowered.
Adjustment after replacing the Printer mechanism
When removing or replacing the Printer mechanism with new one, the
following adjustment must be performed in the order below.
1) Drain ink counter reset
2) Gap adjustment (Bi-d adjustment)
3) Top margin adjustment
4) 1st dot position adjustment
However, in case that you perform the operation with Printer mechanism
without the Lower housing in urgent case, the procedures from the next page
should be followed surely.
Disassembly and Assembly
Do not remove or replace the Paper eject roller and M/B mounting plate from
Printer mechanism.
When the Spur gear 60 and the Paper eject roller shaft is removed from
the Printer mechanism, the hooks on the Paper eject roller is damaged.
Therefore, do not use them again because the paper feeding accuracy is
lowered.
Figure 4-57. Hooks on the Paper eject roller shaft
The Paper eject roller and the Spur gear 60 is not established for service part.
Disassembly
Hooks on the Paper eject roller shaft
Revision A
103