Replacing The Speaker/Power Led Assembly - Sun Microsystems SPARCclassic Service Manual

Figure 8–2

Replacing the Speaker/Power LED Assembly

To replace the speaker/power LED assembly:
1. Remove the faulty speaker/power LED assembly as described in the previous
section.
2. Squeeze the replacement speaker assembly where indicated in Figure 8–2 and
slide it down into its channel guides until it snaps into place.
Caution -
or the sound quality.
3. Reconnect the speaker/LED cable to its connector on the main logic board.
The connector is keyed to fit only one way. For the connector location, see
Chapter 11.
SPARCclassic/SPARCclassic X/SPARCstation LX Service Manual ♦ Revision A, November 1993
64
Removing and Replacing the Speaker/Power LED Assembly
Do not touch or press on the speaker cone. You may damage the speaker