Use Video Process (Process) - JRC JMA-5212-4/6 User Manual

3.5.13 Use Video Process (Process)

This function reduces unnecessary noise to highlight targets.
z When viewing a radar beacon, SART signal, or fast
moving target on the radar display, select PROC Off
(video processing off).
z If video processing mode is set to CORREL , it may
be difficult to detect high speed target.
Procedure 1
2
3
Video process modes
PROC OFF
3SCAN COREL Correlative process 1: Select this mode when many rain/snow clutter returns are
4SCAN COREL Correlative process 2: Select this mode to highlight targets while suppressing sea clutter
5SCAN COREL Correlative process 3: Select this mode to detect small targets hidden by sea clutter
REMAIN
PEAK HOLD
* Software button
available for switching video process modes.
Attention
Press [RADAR MENU] key twice.
The Radar Menu will appear.
Press [2] key.
The Process Selection Menu will appear.
Select the mode number to be set,
pressing the numeric keys [1] to [6].
The selected mode will be set.
Video process off:
Video process 4:
Video process 5:
located at the bottom left corner of the radar display described in Section 2.3.2 is also
Select this mode in general.
detected.
returns.
returns.
Select this mode when own ship yaws wildly.
Select this mode to detect small targets of which detection
probability is low.
3 57