JRC JMA-5212-4/6 User Manual page 168

2 Making navigation information (Make Map Object)
Procedure 1
2
3
4
5
6
Note: Navigation information can be created with a maximum of 256 points being plotted.
The number of points that can still be plotted (REMAIN POINT in the menu) is decremented
each time a line or mark is plotted.
Press [2] key while the Edit User MAP
Menu is open.
The Make Map Object Menu will appear.
MAKE will appear in the CURSOR mode
field at software button
right corner of the radar display described in
Section 2.3.4.
Select the type of navigation
information to be made, pressing the
corresponding numeric key.
Use the trackball to move the cross
cursor mark to the starting point of a
line or a point where a mark is to be
made, and press [ENT] key.
The starting point of a line or one point of a mark will be determined.
Repeat step 3, and press [8] key when finishing the making of the line or
mark.
The line or mark make mode will terminate.
To make another line or mark, repeat steps 2 to 4.
Press [0] key when finishing the making of all navigation information.
The Edit User Map Menu will reappear.
located at the bottom
3 89