Use Function Switch [Func]; Operation Procedure - JRC JMA-5212-4/6 User Manual

3.10

USE FUNCTION SWITCH [FUNC]

"Radar Function Setting" is provided for always obtaining the best radar video by storing complex radar signal
processing settings in the optimum status by use, and calling the setting in accordance with the conditions for
using the function.
Functions are factory-set for general use, and the settings can be fine adjusted by operating the menu.
Four function modes are available, and they are factory-set as follows:
Function 1: COAST
Function 2: DEEP SEA
Function 3: FISH NET
Function 4: STORM

3.10.1 Operation Procedure

Calling a Function
Procedure 1
Changing Function Setting (temporary change)
x When radar signal processing setting is changed by using the menu or button on the radar
display while function 1 to 4 is called, the change is temporarily reflected to the operating state.
x Since this method does not change the memory contents, the new setting is deleted as soon as
another function is called.
x When the previous function is called again, operation is performed according to the memory
contents.
Changing Function Setting (memory contents change)
x To change the memory contents of functions 1 to 4, use the function setting menu.
x To display the function setting menu, press [RADAR MENU] twice, [6] key, and then [8] key.
x Press the numeric key corresponding to the target function number.
x The function setting menu consists of five pages. To switch between the pages, select [0] key
Previous Page or [9] key Next Page.
Useful for observing short-range videos
Suitable for general ocean navigation
Useful for small target.
Useful for observing videos in stormy weather
Press the [FUNC] key.
Each time the [FUNC] key is pressed, the selection changes cyclically as follows:
Function Off o Function 1 o Function 2 o Function 3 o Function 4 o Function Off
The currently called function mode will be indicated at the lower left of the radar display.
* Switching can be done each time software button
of the radar display described in Section 2.3.2 is pressed.
3 137
located at the bottom left corner