JRC JMA-5212-4/6 User Manual page 422

Step 3: Remove the cable.
J210
J209
J1
J3
J2
Cover
Screws (4 places)
Cable clamp screw
(1 place)
J1502
J125
J4
J5
J1504
8 27
Loosen all the screws (4 places).
Slide the cover to the left and remove it.
Remove the encoder connector (1 place).
(J209)
Remove the equipment cable connectors
(5 places).
(J1 through J5)
Remove the safety switch connectors
(2 places).
(J210 and J1504)
Remove the motor connector (2 places).
(J1502 and J125)
Remove 10 connectors in total.
* When a PM monitor (optional) is installed,
remove the connectors (2 places) and then
remove the screwed ground terminal.
Remove the screw (1 place) and remove the
cable clamp as well as the equipment cable.