Acquiring Target [Acq] - JRC JMA-5212-4/6 User Manual

5.2.1 Acquiring Target [ACQ]

Target acquisition can be performed on two modes, AUTO and MANUAL, and both modes can be used at the
same time.
Automatic Acquisition [AUTO]
z If untracked targets intrude into automatic
acquisition/activate zone in the conditions that
maximum number of targets is under tracking, the
targets acquired automatically will be cancelled in
the order of lower levels of danger.
Procedure 1
2
Attention
Press the [AZ] key.
Automatic acquisition will be started. The mark "
an acquired target, and they move together with the target. The vectors are displayed
within one minute.
Press the [AZ] key again.
Automatic acquisition will be turned off, and automatic acquisition/activate zone
disappears from the radar display. However, automatically acquired ships are
continuously tracked.
For automatic acquisition/activate zone to be called by using the [AZ] key, refer to
"Setting Automatic Acquisition Key Assignment (Set AZ Key)" on the next page.
5 19
" and target ID number are put to