Configuring Miscellaneous Features; Communication; General Guidance - "Communication" Flow-Chart & Menu Options - Visonic PowerMaster-10 Installer's Manual

5. PROGRAMMING

5.5.8 Configuring Miscellaneous Features

The following table provides you with a detailed description of each option and its configuration settings. To select an
option and change its configuration – refer to section 5.5.1.
Option
91:USER PERMIT
1
92:BATTERY TYPE

5.6 Communication

5.6.1 General Guidance – "Communication" Flow-Chart & Menu Options
The COMMUNICATION menu enables you to configure and customize the communication and reporting of alarm,
troubles and other system events for monitoring companies or private users according to your local requirements and
personal preferences. PowerMaster offers a variety of communication means including telephone PSTN landline,
Cellular GSM, GPRS or SMS and IP via broadband internet connection.
The "04.COMMUNICATION" menu contains several sub-menu options, each covering a group of configurable features
and parameters related to the communication and reporting as follows (see detailed list in Step 3 of the chart below):
Option
1:PSTN TEL LINE
2:GSM/GPRS/SMS
3:C.S.REPORTING
4:PRIVATE REPORT
5:MOTION CAMERA
6:UP/DOWNLOAD
To enter the "04.COMMUNICATION" menu and to select and configure an option, proceed as follows:
Step 1
Select "COMMUNICATION"

INSTALLER MODE

04.COMMUNICATION
1
Refers to PowerMaster-30 G2 only
42
Configuration Instructions
User Permission enables you to determine whether access to the INSTALLER MODE requires
the user's permission or not. If you select enabled, the installer will be able to access the system
only through the user menu after the user code has been entered (see section 5.2).
Options: disable (default) or enable (default in UK).
Note: To comply with EN requirements, "Enable" must be selected.
Define which type of battery pack is used for the system to supply proper charge current.
Options: 7.2V NiMH (default) or 9.6V NiMH (default in UK).
Description of Option Features and Parameters
Contains configurable features and parameters related to the PSTN telephone line
to which the PowerMaster is connected.
Contains configurable features and parameters related to the Cellular connection
of the PowerMaster system.
Contains configurable features and parameters related to Reporting of event
messages to Monitoring Stations via telephone, cellular or IP broadband
communication.
Contains configurable features and parameters related to Reporting event
messages to Private Users via telephone or SMS.
Contains configurable features and parameters related to Motion Cameras for
Video Alarm Verification and forwarding of image clips to the Monitoring Station
and other remote subscribers via e-mail and/or MMS network.
Contains configurable connection information, access permission and security
codes related to the Upload/Download procedures via PSTN or GPRS.
Step 2
Select Communication
Sub-menu option

1:PSTN TEL LINE

2:GSM/GPRS/SMS

Step 3
Select the "Communication" Parameter you wish to configure

AREA CODE SKIP
LINE PREFIX
DIAL METHOD
GPRS REPORT
GSM REPORT
SMS REPORT
GPRS APN
GPRS USERNAME
SIM PIN CODE
D-303222 PowerMaster-10/30 G2 Installer's Guide

GPRS PASSWORD
NETWORK ROAMING
GPRS ALWAYS ON
GSM KEEP ALIVE
TRANS. PROTOCOL
Section
5.6.2
5.6.3
5.6.4
5.6.5
5.6.6
5.6.7
Step 4
See
5.6.2
5.6.3