Visonic PowerMaster-10 Installer's Manual page 79

Record Speech
This section is an update to the PowerMaster-10/30 G2 Installer's Guide – section 3.8.2
You can record short-duration speech messages for the house identity, user names and custom zone names.
For the recording procedure follow the instructions below. Additional details and guidance are provided in section 5.2.
06:CUSTOM NAMES
Enter "RECORD SPEECH", select the menu you wish to perform (see guidance above), then refer to the tables below
which provide you with detailed explanations for each option.
Option
HOUSE IDENTITY
To advance to the next stage in the recording procedure; from the "HOUSE IDENTITY" menu, click
Option
USER #23 VOICE
VOICE LOC. #1
Operation Mode
This section is a new feature in the PowerMaster-10/30 G2 Installer's Guide.
Note: The Operation Mode feature is applicable only in specific PowerMaster variants.
General Guidance – "Operation Mode" Menu
This new feature allows selection of the active operation mode of the control panel in order to comply with different
standards such as EN-50131, DD243 and BS8243. Each operation mode has its own configuration, which overrides
the generic panel setup.
Select between EN-50131, DD243 and BS8243
To select the desired operation mode, proceed as follows:
Step 1
Select "13:OPERATION MOD" menu
13:OPERATION MOD
Note: If "EN-50131" is selected, the control panel will operate according to the regular settings of the control panel.
2
⋅ ⋅ ⋅
RECORD SPEECH
Instructions
You can record a message to be announced automatically when events are reported to
private telephones.
While in "RECORD SPEECH", press
alternates with "REC-<2> PLAY-<5>" (this means, press the
button to play recording).
To initiate the recording procedure, press the
message; "RECORD A MESSAGE" appears momentarily and then changes to
"TALK NOW " (the square boxes slowly disappear, one by one, until the end of the
recording time).
At the end of the recording process, the panel will display the following:
"RECORDING ENDED". Release the
Note: To check the recorded message, press the
Instructions
You can record ten user names and assign them to users 23-32. In case of event, the
relevant user name will be added to the message that will be reported via the telephone.
Record user names for 23-32; the procedure is identical to the "HOUSE IDENTITY" recording
procedure described above. Click
You can record user terms 1- 5 (for example, Living room, Library, etc.), and assign them to
specific zones. These names are useful if none of the 26 fixed zone names are found
suitable for a certain zone. When done, press
Record user terms 1-5; the procedure is identical to the "HOUSE IDENTITY" recording
procedure described above. Click
Step 2
Enter "01:SELECT MODE"
01 SELECT MODE
; the display now reads "HOUSE IDENTITY" and
button continuously to record your
button.
button and listen to the playback.
to navigate between user name numbers.
to return.
to navigate between user term numbers.
Step 3
Select "EN-50131", "DD243" or
"BS8243"
EN-50131
D-304271 PowerMaster-10/30 G2 Addendum
button to record and the
.
Step 4
to Step 2