Avalanche Console Commands; Port Commands - Avery Dennison Monarch 9460 SNP System Administrator Manual

SEt SERVEr SYSLog [EN/DIS]
Enables or disables access to the system log.
SHow FATal
Shows the fatal error log.
SHow FREE
Shows the amount of available memory.
UNPROTect
Allows the user to enter the update password (if one has been defined). Once the update
password is entered correctly, SET commands can be used to modify the configuration until the
console session is closed with EXIT.
ZEro
Zeros statistical counts.
A v a l a n c h e C o n s o l e C o m m a n d s
DELete AVAlanche PROPerty <name>
Removes an Avalanche property.
Note: This allows the user to delete system-defined properties. However, they are
recreated on a restart.
SEt AVAlanche IP <ip address>
Sets the address of the Avalanche Agent.
SEt AVAlanche <EN/DIS>
Enables or disables the Avalanche Enabler.
SEt AVAlanche PROPerty <name> <property value>
Adds an Avalanche property.
P o r t C o m m a n d s
SEt POrt <name>
Sets the name of the communications port.
SHow POrt <name> STA
Shows the current port status.
8 0 2 . 1 1 b / g W i r e l e s s C o m m a n d s
CLear NW SSid
Clears the SSID, so the server connects to any access point.
SEt NW APDEN [LOW/MED/HI]
Sets 802.11b/g access point density.
Note: This command is not supported with the PegIV radio.
SEt NW AUTHTRY n
Specifies the number of authentication tries the user is given.
SEt NW AUTHtype [OPEN/SHARED/TLS/TTLS/LEAP/PEAP/EAP-FAST/PSK]
Sets the authentication type. See Chapter 4, "Using a Web Browser" for more information.
SEt NW CERTCN <name>
Sets the EAP common name. If no value is set (null), all host certificates are accepted.
SEt NW CERTCN2 <name>
Sets the second EAP common name. If no value is set (null), all host certificates are accepted.
SEt NW CERTEXP <value>
Sets the EAP certificate exponent value.
Telnet Console Commands 6-5