Controlling Ip Access; To Add Hosts; To Remove Hosts - Avery Dennison Monarch 9460 SNP System Administrator Manual

You must re-enter your access password to make any further changes to the
printer settings.
C o n t r o l l i n g I P A c c e s s
You can limit which remote hosts are able to access the printer by setting up an IP
1.
address range.
From the side menu, click Admin. The Web Admin Configuration screen appears.
2.
Click Configure IP Access Control.
3.

To Add Hosts:

You can specify the valid range of remote IP addresses.
Enter a range of remote IP addresses that are allowed access to the printer. Any
1.
requests from hosts outside this range are rejected.
Click Add.
2.
Click the reset link at the bottom of the screen. The Reset Server screen appears.
3.
Click Submit and wait five seconds for the print server to reset.
4.
Even though you submitted your changes, they do not take effect until you reset the
print server.
You must re-enter your access password to make any further changes to the printer
settings.
The range of accepted IP addresses is listed in the drop-down menu.
5.

To Remove Hosts

You can remove a range of remote IP addresses.
Select a range from the drop-down menu.
1.
Click Remove.
2.
Click the reset link at the bottom of the screen. The Reset Server screen appears.
3.
Click Submit and wait five seconds for the print server to reset.
4.
Even though you submitted your changes, they do not take effect until you reset
the print server.
You must re-enter your access password to make any further changes to the
printer settings.
4-12 System Administrator's Guide