Tcp/Ip Commands - Avery Dennison Monarch 9460 SNP System Administrator Manual

Set NW SCAN <channel list> [DISable/ENable]
Sets the scanned channels for access points. The default is to scan all available channels on the
specified band (802.11b for example); however, this command restricts which channels are
scanned.
SEt NW SPeed <1/2/5.5/6/9/11/12/18/24/36/48/54>
Sets 802.11b/g wireless speed in megabits per second (Mpbs).
SEt NW SSid "<ssid>"
Sets 802.11b/g wireless SSID. Use quotes if there is a space in SSID. This is case sensitive.
SH NW STATS
Shows the network I/O statistics.
Set NW TXPOWER <0-100>
Reduces the transmit power based on the percentage entered.
SEt NW WEP [DIS/64/128]
Sets wired equivalent privacy encryption level to disabled, 64-bit, or 128-bit.
SEt NW WIRED [AUTO/10BASE/100BASE]
Sets the Ethernet speed.
SEt NW WPAAUTO [DISable/ENable]
Enables or disables WPA auto mode. When enabled, the printer server connects to a non-WPA
access point if a WPA-enabled access point is not available.
Note: Only valid when WPA is enabled using TKIP authentication.
SEt NW WPAGROUP [ENABLE/DISABLE]
Enables or disables the WPA group key mode. When enabled, group keys are used for data link
encryption.
SEt NW WPAPSK <psk-str>
Sets the WPA pre-shared key or pass-phrase. Use 64 hex characters for the PSK or 8-63
characters for the pass-phrase. This is only valid when authentication mode is WPA-PSK.
T C P / I P C o m m a n d s
SEt IP [EN/DIS]
Enables or disables IP-based protocols.
SEt IP ACcess [EN] aa.bb.cc.dd
[Mask ee.ff.gg.hh]
Allows or prevents specified IP address from accessing print server.
SEt IP ADdress
Sets IP address of print server.
SEt IP ARP [EN/DIS]
Enables or disables an IP address with an ARP packet.
6-8 System Administrator's Guide