Table of Contents
Advertisement
T E L N E T C O N S O L E C O M M A N D S
Use this chapter to configure the print server using Telnet. You must have a basic
understanding of Telnet commands. For initial setup, do not use Telnet. Use auto-
discover mode. Once you have the IP address, you can use Telnet or a Web browser.
The default port is Port 23. You can use Telnet if you do not have access to the
NetManager software.
To access Telnet console mode:
Start Telnet.
1.
Press Enter (on your host) until you see the "#" prompt.
2.
Type
as the password and press Enter. (access is the default password.)
3.
access
Press Enter to by-pass the user name. You do not need to enter a username.
4.
Note:
The Telnet session times out after 10 minutes of inactivity.
Differences in supported features and commands exist with the radio versions
(Peg3 vs. Peg4).
C o n v e n t i o n s
This section uses the following conventions:
KEYwords
Type the capitalized letters of each keyword instead of the whole keyword.
Some keywords require more capitalized letters than others. For example,
SEt
KEYVAL
RAdio
[options]
Mutually-exclusive options are included within square brackets and separated
by a forward slash. Select only ONE of the options. For example,
[DISable/STRICT/FLEXible]
<values>
Values are included within brackets. Values that contain spaces (multiple
words) must be enclosed within quotation marks (""). For example,
SEt NW PW <value>
SEt NW PW "Store 876"
n
Numeric digits are indicated by the letter (n). For example,
SEt IP BOot n
SEt IP BOot 5
SEt NW CHannel nn
SEt NW CHannel 11
S e t t i n g s
To view the current wireless settings, type
1.
Enter:
WiFi Mode = INFRASTRUCTURE
WiFi SSID: ABC1234
Speed = 54
International Roaming: Flexible
Dynamic Frequency Selection: Unsupported
Regulatory Domain = USI
WiFi FW Ver = 2.13.10.0 LMAC, 2.12.18.0 UMAC
AP density = LOW
Authentication type= OPEN SYSTEM
Encryption is Disabled
Local certificate loaded
AP MAC Address = 00 A0 F8 51 B4 FC
Signal Quality = Excellent (100%)
Connected to SSID ENG4121 on channel 11
(show network settings) and press
sh nw
Telnet Console Commands 6-1
6
Advertisement
Table of Contents
Troubleshooting
