Setting Up The 9460™ Printer - Avery Dennison Monarch 9460 SNP System Administrator Manual

S e t t i n g U p t h e 9 4 6 0 ™ P r i n t e r
Use these instructions to set up a 9460 printer using the printer's RF Network menu in the
printer's Tool Box.
1. Turn on the printer by pressing and holding the power button (P) until the display
turns on.
The display flashes printer version information and battery charging status.
E B
Init Radio..........
When you see "Init Radio", the printer is waiting for the wireless print server to
initialize.
Next, you may see
Ready
p
<T>
Display Indicates
Ready The printer is in Ready mode to send and receive data.
<T> The printer is connected to a network (peer-to-peer or infrastructure mode).
Press A under <T> to display the printer's IP address, then press A under
to print a network information label with the device name, IP address, and
MAC address as a bar code. See "Printing a Network Information Label" for
more information.
Press any button to return to Ready mode.
The printer is not connected to a network.
2. Press A under p.
E B
R
X
You see the battery indicator E (empty) and F (full). As you use the printer, the
battery indicator line gets closer to E (empty), instead of F (full). Recharge the
battery when the line is by the E.
3. Press T (Tool Box) to enter the menu.
Tool Box
Language
E D
4. Tool Box is highlighted. Press E to select Tool Box.
Enter Password
2-4 System Administrator's Guide
F
F
T