Snmp Ip Traps - Avery Dennison Monarch 9460 SNP System Administrator Manual

SNMP IP Traps

You can configure the SNMP IP traps.
From the Alerts and Traps page, click SNMP IP Traps.
1.
Enter a community name, IP address, and the trigger conditions for an email alert.
2.
You can enter up to eight IP addresses.
Note: The S1 port acts as a toggle switch to enable or disable the alerts. You must
select S1 to enable the alerts.
Click Submit.
3.
Click the reset link at the bottom of the screen. The Reset Server screen appears.
4.
Click Submit and wait five seconds for the print server to reset.
5.
Even though you submitted your changes, they do not take effect until you reset the
print server.
You must re-enter your access password to make any further changes to the printer
settings.
4-8 System Administrator's Guide