Configuring the Printer
The Configure menu allows you to set the printer's IP address, subnet mask, gateway,
power mode, protocol, SSID, and escape character.
To exit, press F at any time.
Setting the IP Address
This option sets the printer's IP address.
1. From the RF Network menu, select Configure.
2. From the Configure menu, select IP Address.
IP Address
192.0.0.192
E
R
For:
Select:
BOOTP
0.0.0.0
DHCP
0.0.0.1
Static IP
nnn.nnn.nnn.nnn
Use the A buttons as shown in the following table:
E
Press A to
Saves the setting
1. When the setting you want is displayed, press E to save the setting. You return to the
Configure menu.
Setting the Subnet Mask
This option sets the printer's subnet mask.
1. From the Configure menu, select Subnet Mask.
Subnet Mask
255.255.000.000
E
R
Use A as shown in the following table:
E
Press A to
Saves the setting
2. When the setting you want is displayed, press E to save the setting. You return to the
Configure menu.
2-6 System Administrator's Guide
+
R
Press A to
Scrolls through the positions
from left to right
+
R
Press A to
Scrolls through the positions
from left to right
+
Press A to
Increments the current
position setting by 1
+
Press A to
Increments the current
position setting by 1