System Requirements; Network Protocols Supported; 9493™ Printer Hardware - Avery Dennison Monarch 9460 SNP System Administrator Manual

S y s t e m R e q u i r e m e n t s
To use the print server for printing from a wireless network, you need an 802.11b/g
wireless network. The wireless network consists of either of the following:

An 802.11b/g wireless enabled computer printing straight to the printer (Ad-Hoc, or
peer-to-peer, mode).

An 802.11b/g wireless access point allowing wireless enabled computers to print to
the print server (infrastructure mode).
To configure and print, you need the following information from your wireless network
administrator:

The SSID (service set identifier) for your wireless network.

If you are using TCP/IP (recommended for Windows Networks) and are not connected
to a server that automatically assigns your IP address, you need to set the printer in
Static mode and assign a unique IP address (for example: 192.168.1.14) and a subnet
mask. A router (default gateway) address is optional.

Wireless security settings
N e t w o r k P r o t o c o l s S u p p o r t e d

TCP/IP:
LPD/LPR, FTP, or IPP
Raw TCP/IP (port 9100 or any chosen port)
NetBIOS over IP (with SMB)
NetWare (NEST)
NetBEUI
DLC

Telnet

WINS

DHCP
9 4 9 3 ™ P r i n t e r H a r d w a r e
To access the Ethernet port, open the hinged door on the side of the printer by loosening
the two screws with a Phillips screwdriver.
1-2 System Administrator's Guide
Ethernet Port