C h a n g i n g T C P / I P S e t t i n g s
You can enable TCP/IP, select applications, set the IP Address, Subnet Mask, and more.
From the side menu, click TCP/IP.
1.
Click the name of the enabled service to modify the TCP/IP parameters for that
2.
service. See "Configuring Print Services" for more information.
You can change protocols, assign an IP address, subnet mask, gateway and more.
3.
Note:
If you disable the IP protocol, you will not be able to configure the printer from
your Web browser.
When you are finished, click Submit.
4.
Click the reset link at the bottom of the screen. The Reset Server screen appears.
5.
Click Submit and wait five seconds for the print server to reset.
6.
Even though you submitted your changes, they do not take effect until you reset the
print server.
You must re-enter your access password to make any further changes to the printer
settings.
C o n f i g u r i n g P r i n t r a N e t
You can enable POP3, set the Server Address, Mailbox Name, Password and more.
From the side menu, click PrintraNet.
1.
Enter the IP address of the POP3 or SMTP server on your network where internet
2.
print jobs are located.
You may also specify a mailbox name and password. For no password required,
enter a single space in the field provided.
Click Submit.
3.
Click the reset link at the bottom of the screen. The Reset Server screen appears.
4.
Click Submit and wait five seconds for the print server to reset.
5.
Even though you submitted your changes, they do not take effect until you reset the
print server.
You must re-enter your access password to make any further changes to the printer
settings.
Using a Web Browser 4-5