Snmp Commands; Email Alerts - Avery Dennison Monarch 9460 SNP System Administrator Manual

SEt IP TRAP n POrt n
Specifies the port that will be scanned for trigger conditions. The parameter is a bit mask.
SEt IP TRAP n TRIGger cccc
Specifies the trigger conditions (cccc) that send a trap (n). The parameter is a
bit mask.
1 On line
2 Off line
4 (not used)
10 Paper out
20 Paper jam
8000 Printer error
SEt IP WIndow nn
Sets the LPD/TCP maximum window size (nn).
S N M P C o m m a n d s
CLear SNMP CONtact <string>
Removes SNMP SysContact.
CLear SNMP LOCation <string>
Removes SNMP SysLocation.
SEt SNMP CONtact
Sets SNMP SysContact.
SEt SNMP LOCation <string>
Sets SNMP SysLocation.
SEt SNMP GETCOMM
Gets SNMP community.
SEt SNMP JETADmin [EN|DIS]
Enables or disables the JetAdmin protocol.
SEt SNMP SETCOMM1 <string> or SET SNMP SETCOMM2 <string>
Sets SNMP community 1 or community 2 name.
Note: An incoming set request can use either name for comm1 or comm2.
SEt SNMP TRAPCOMM <string>
Sets SNMP trap community name.
E m a i l A l e r t s
SEt SMTP TRAP n ADDR <mail@address>
Sets the destination SMTP email address specifying where to send the alert.
SEt SMTP TRAP n PORT n
Specifies the ports scanned for trigger conditions. The parameter is a bit mask, with bit zero
corresponding to port 1, bit 1 port 2, etc.
SET SMTP TRAP n TRIGger cccc
Specifies the trigger conditions (cccc) that cause an alert. The parameter is a
bit mask.
1 On line
2 Off line
4 (not used)
10 Paper out
20 Paper jam
8000 Printer error
DEL SMTP TRAP n
Deletes the configuration of the specified email alert.
6-10 System Administrator's Guide
<string>
<string>