Security Menu; Lan Settings Submenu - Fujitsu PRIMERGY TX300 S4 User Manual

LAN Settings submenu

This submenu is for LAN settings for when performing remote operation by using
RemoteControlService.
Item
DHCP
Local IP address
Subnet mask
Gateway address
Service LAN
Service LAN Port

7.2.11 Security Menu

This menu is for setting security options.
Main Advanced
Setup Password
System Password
Set Setup Password:
Setup Password Lock:
Set System Password:
System Password Mode:
System Load:
Setup Prompt:
Virus Warning:
Diskette Write:
Flash Write:
>
TPM (Security Chip) Setting
F1
Esc Exit
Item
Setup Password
System Password
table: LAN Settings submenu
Setting
• Disabled (Initial value)
• Enabled
[000.000.000.001]
[000.000.000.000]
[000.000.000.000]
• Disabled
• Enabled (Unchangeable)
Service (Unchangeable)
PhoenixBIOS Setup Utility
Security Server
Not Installed
Not Installed
[Press Enter]
[Standard]
[Press Enter]
[System]
[Standard]
[Enabled]
[Disabled]
[Enabled]
[Enabled]
-/+ Change Values
Select Item
Select Menu Enter Select > Sub-Menu
table: Security menu
Setting
Displays if a password required for the setup (setup password) is set.
When the password is not set, "Not Installed" is displayed.
When the password is set, "Installed" is displayed.
Displays if an administrator password (system password) is set.
When the password is not set, "Not Installed" is displayed.
When the password is set, "Installed" is displayed.
PRIMERGY TX300 S4 User's Guide
Description
Sets whether to acquire LAN IP address of the Remote
Management Controller port from the DHCP server.
Enter the IP address of the Remote Management
Controller port.
Enter the subnet mask of the Remote Management
Controller port specified in [Local IP address].
Enter the gateway address of the Remote Management
Controller port specified in [Local IP address].
Sets whether to enable the Remote Management
Controller port.
Appears when [Service LAN] is "Enabled".
Exit
Item Specific Help
Setup Defaults
F9
Description
207