Keyboard Connector; Mouse Connector; Serial Port - Fujitsu PRIMERGY TX300 S4 User Manual

Chapter 1 Overview
f System status LED
This LED is lit or blinking yellow when an error is detected in the server components. If this
LED is lit or blinking, contact an office listed in the "Contact Information" of "Start Guide".
g Keyboard connector (
Connect a keyboard.
h Mouse connector (
Connect a mouse cable.
i Serial port (
Connect cables of peripheral equipment conforming to the RS-232C standard such as a modem.
j Display connector (
Connect a display cable.
k USB connector (
Connect peripheral equipment conforming to the USB standard (2.0 or 1.1).
l Service LAN Port
The LAN port is for the Remote Management Controller. By connecting a LAN cable, you can
use the Remote Management Controller function from Web interface. For how to use the Remote
Management Controller, refer to "Appendix D Remote Management Controller" ( pg.267).
m LAN port 1 (10/100/1000BASE-T) (
Connect an Unshielded Twisted Pair (UTP).
For 1000Mbps connection, a category 5 enhanced or a category 6 cable is required.
For 10Mbps/100Mbps connection, a category 5 or higher cable is required.
The LEDs as shown below indicate the following status.
LED
LED
location
Upper LED
Lower LED
n LAN port 2 (10/100/1000BASE-T) (
Connect an Unshielded Twisted Pair (UTP). The cables to be used and meanings of the two
LEDs are the same as those for the LAN port 1.
26
)
)
)
)
)
table: Meaning of the LAN port LED
LED status
Link is being established
Green
Data is being transferred
Green (blinking)
Off Link is not established
Connection established at 1000 Mbps
Amber
Connection established at 100 Mbps
Green
Off Connection established at 10 Mbps or
no LAN cables connected
)
Connection status
)