Setting Up Printers; Adapter Numbers - Fujitsu PRIMERGY TX300 S4 User Manual

Exiting ServerStart
After operation in the Expert mode, exiting ServerStart restarts the system. Remove discs from the
floppy disk and CD/DVD drives, and click [OK]. When the display on the screen disappears, turn off the
system.
License for use of system for ServerStart
"License for Use of System for ServerStart" linked from the ServerStart startup window is a license for
use of Windows PE contained in ServerStart of the PRIMERGY Startup Disc. Windows PE for starting
up ServerStart can be only used for installing Windows Server 2008, Windows Server 2003 R2, and
Windows Server 2003, provided under a separate legal license.
Display of onboard LAN
Display of an onboard LAN on your OS is as below when OS installation is performed with ServerStart.
LAN port
Onboard LAN

Adapter numbers

For ServerStart, onboard multiple LAN adapters (network adapter) can be configured with OS
installation wizard. To configure multiple LAN cards, select the adapter numbers in order of Adapter 1
and Adapter 2, and enter settings for each adapter. Note that the order of adapter numbers is not
necessarily the same as the order of slots for the installed LAN adapters. This means that the setting for
Adapter 1 is not always applied to the onboard LAN. After installing the OS, check the LAN adapters to
make sure that they are configured as intended.

Setting up printers

ServerStart does not support setup of printers. Perform installation after setup is completed.
table: Display of onboard LAN
Property on My Network
Local Area Connection
PRIMERGY TX300 S4 User's Guide
LAN device name
BroadcomNetXtreme Gigabit Ethernet
51