Teaming Setting Procedure - Fujitsu PRIMERGY TX300 S4 User Manual

Chapter 4 Operations after OS Installation
Notes
• Once a Windows Server 2003 Team is created, virtual adapters (BASP Virtual Adapter) will be
created in the [Device Manager] and [Network Connections] of the system. Do not disable or delete a
virtual adapter from the [Device Manager] or [Network Connections].
When deleting a virtual adapter, make sure to use BACS.
• When using teaming, only use IP protocols.
• When using teaming, Windows Load Balancing Server (WLBS) and Network Load Balancing
(NLB) cannot be used.
• When an onboard LAN is used with RemoteControlService, the onboard LAN cannot be
incorporated into a team. If the onboard LAN where remote control is set by RemoteControlService
is incorporated into a team, remote control of RemoteControlService is not performed correctly. For
remote control by RemoteControlService, refer to "ServerView User's Guide".
• When turning on the server via an onboard LAN that is a team member, send all the following
packets to the onboard LAN.
• The power supply control packet with MAC address of the onboard LAN which turns on the server
specified
• The power supply control packet with MAC address of another port in the team specified
Errors that Teaming can detect
When Smart Load Balancing or FEC/GEC Generic Trunking is selected, only a link down error
between an onboard LAN and the switch it connects with, and the equivalent errors lead to switching
of the route used in a team. Therefore, if only the switch or onboard LAN is partially damaged and the
route being used is normal at the link level, the route may not be switched in the team and the
communication using team may become an error.
When the mode is 802.3ad Link Aggregation using Link Aggregation Control Protocol (LACP), the
route will be switched from the port where error is detected to a normal port according to the LACP
protocols.

4.6.4 Teaming Setting Procedure

Follow the procedure below to set Teaming.
1
Log on as an administrator or a user with administrator privileges.
2
Click [Start] – [Control Panel] – [Broadcom Control Suite 3].
BACS3 starts.
108