Fujitsu PRIMERGY TX300 S4 User Manual page 158

Chapter 6 Installing Internal Options
6
Install the memory board 2 to the memory board slot 2.
Memory board slot 2
7
Remove the panel behind the ventilation duct.
To remove the panel, release the lock by pressing the following position (1), and push the panel
to direction as shown figure below (2). When it is difficult to release the lock, press the position
by using a flathead screwdriver.
8
Attach the ventilation duct.
To attach the ventilation duct, simply reverse the removal procedures.
9
Attach the side cover.
158
Press here.
(1)
(2)