Vlan - Fujitsu PRIMERGY TX300 S4 User Manual

Chapter 4 Operations after OS Installation

4.7.3 VLAN

Notes
Note the following when you configure a VLAN by using Intel
PROSet help. However, when there is difference in content between this manual and Intel
help, follow this manual.
• Up to four VLANs whose "NetBIOS over TCP/IP" is enabled in the whole system.
• Only ten or less VLANs can be set to a LAN port.
• When adding or deleting a VLAN, always use "Intel
from the [Device Manager] or [Network Connections].
• On a VLAN, only use IP protocols. Do not use other protocols.
When LLC and the LNDFC protocols are installed by the Fujitsu communication control service,
these protocols are bound (connected) unconditionally. Therefore, release the bind of VLAN and
these protocols in the system where these protocols and VLAN are installed at the same time.
Creating VLAN
1
Click [Start] – [Administrative Tools] – [Computer Management] to start up
®
Intel PROSet.
2
Under [Device Manager], click [Network adapters], and double-click a LAN
adapter to set a VLAN.
3
Click the [VLANs] tab, and click [New...].
4
Specify [VLAN ID] and [VLAN Name]. Then click [OK].
The [VLAN ID] should be identical with the switch setting. The configuration range 1 to 4094
can be specified. Any name can be specified as the [VLAN Name].
5
Click [OK] to close the property window for the LAN adapter.
When setup of the VLAN is completed, virtual adapter "(LAN Adapter Name)-VLAN:(VLAN
Name)" will be created.
Upper protocols will be bound with the main virtual adapter. They cannot be bound with the
LAN card configuring a VLAN. The IP address should be specified in the main virtual adapter.
124
®
PROSet. For details, refer to Intel
®
PROSet". Do not disable or delete a VLAN
®
®
PROSet