Setting A Password - Fujitsu PRIMERGY TX300 S4 User Manual

Chapter 8 Operation and Maintenance
Administrator password (System password)
This is the password that only allows the administrator to set up this server. Unless the set password is
entered, the BIOS setup cannot be accessed and the OS cannot be booted.

Setting a password

The password is set in BIOS Setup Utility. For details on BIOS Setup Utility, refer to"7.2.11 Security
Menu" ( pg.207).
1
Start up BIOS Setup Utility.
"7.2.1 Starting and Exiting BIOS Setup Utility" (pg.193)
2
Select the [Security] menu, and select the password type to be set.
• For the administrator password, select [Set System Password], and press the [Enter] key.
• For the user password, select [Set Setup Password], and press the [Enter] key.
3
When the password window is displayed, enter the password to be set.
Set Setup(System) Password:
Enter New Password
Confirm New Password
4
Enter the password again to confirm it.
5
Press the [Enter] key.
The password is set.
Changing/deleting a password
If a password is already set, perform the password setting operations above to display the password
change window.
• To change the password, perform the following settings, and press the [Enter] key.
Set Setup(System) Password:
Enter Current Password
Enter New Password
Confirm New Password
• To delete the password, enter the current password, and then press the [Enter] key without entering
anything in the second and third fields. The status of [System (Setup) Password] changes to "Not
installed".
240
Enter the password
[ ]
Enter the password again for confirmation
[ ]
Enter the current password
[ ]
Enter the new password
[ ]
Enter the new password again for confirmation
[ ]