Vlan - Fujitsu PRIMERGY TX300 S4 User Manual

Chapter 4 Operations after OS Installation
18
Click [Yes].

4.6.5 VLAN

Notes
When using a VLAN on BACS, note the following points. For details, refer to help of BACS. However,
there is difference in content between this manual and the help, follow this manual.
• When you create VLAN, a virtual adapter "BASP Virtual Adapter" will be created in the system. Do
not disable or delete this virtual adapter from the [Device Manager]. When deleting the virtual
adapter, make sure to use BACS.
• On a VLAN, only use IP protocols.
When LLC and the LNDFC protocols are installed by the Fujitsu communication control service,
these protocols are bound (connected) unconditionally. Therefore, release the bind of VLAN and
these protocols in the system where these protocols and VLAN are installed at the same time.
• Only ten or less VLANs can be set to a LAN port.
• Up to four VLANs whose "NetBIOS over TCP/IP" is enabled in the whole system.
VLAN setting procedure
Follow the procedure below to set a VLAN.
1
Log on as an administrator or a user with administrator privileges.
2
Click [Start] – [Control Panel] – [Broadcom Control Suite 3].
BACS3 starts.
116