Fujitsu PRIMERGY TX300 S4 User Manual page 57

5
Set configuration of the RAID and disks, and click [Next].
To install the OS while maintaining the established RAID environment
Select "Logical Disk 0", and specify partition size to be created.
One partition can be created. Select "Logical Disk 0" even if the RAID is not required to be
created.
To configure RAID
Select "create new RAID array with one partition", and specify the RAID level to be configured
and the size of the partition.
All existing RAID will be deleted. One partition can be created.
When [Auto] is selected, the RAID is configured with the following levels, depending on the
number of the installed disk units.
• When two hard disk units are installed: RAID 1
• When three hard disk units are installed: RAID 5
• When more than three hard disk units are installed: RAID 5 with hot spare function
The configurations of the created partitions are as follows.
• Volume label: system
• File system: NTFS
• Partition configuration: Boot/OS
The [Please select the OS to install] window appears.
PRIMERGY TX300 S4 User's Guide
57